Cascade Shaker Card

This card is the normal cascade card with a shaker on the front.

CASCADE CARD INSTRUCTIONS

1.Take a piece of card and cut to 21cm x 30cm.
2.Mark the card on the right side 6cm from the bottom and cut from the top left to this point.
3.Cover the back and the front panel with paper.
4.Now cover the middle. All the papers should be facing to the front.
5.Decorate as you wish.

For the Christmas shaker
1.Complete steps 1 and 2 and cover the back panel.
2.Cut the paper to fit the front and then cut a piece of acetate from the acetate Christmas pack the same size(the plain is the best)
3.Cut a piece of card for a frame leave a border of 1.25cm
4.Stick the acetate to the back of the frame and then stick foam tape onto the acetate make sure there are no gaps.
5.Remove the foam backing gently sprinkle a little glitter onto the acetate making sure you do not get it onto the foam tape.
6.Place the paper you previously cut onto the foam tape and then stick this to front of the card.
7.Stamp out a candle from the Christmas stamp set. You will need 4 of these cut away areas and decoupage.
8.Colour in with Whispers Brushmarkers and a blender to soften the colour.
9.Stick this to the card slightly over the acetate window Place an essentials Merry Christmas onto the centre panel.
Apply glitter glue to the candle and allow to dry.